Damp-Proof Interior Wall Putty With Non Toxic Harmless
PB-07 Damp-Proof Skim Coat has strong bonding power, can be well
attached to the wall and coating.
Good anti-crack function, good damp-proof and air permeability
function and keep the wall and the
1, Strong bonding power, can be well attached to the wall and
2, Good anti-crack function.
3, Good damp-proof and air permeability function and keep the wall
and the painting dry.
4, Natural texture, ensure that the decorative effect can be
1, The substrate surface should be firm, dry and clean, no grease,
no wax, and other loose materials.
2, The new plaster surface should be maintained about 12 days
before inserting the skim coat, do not use
cement paste to polish.
3, If the wall is too dry, wet the wall till there is no obvious
water on the surface before operation.
1, The ratio: damp-proof skim coat: water= 20kg/bag: about 4.8~5.6L
2, Pouring water into the container, and adding the powder slowly,
then stirring them into a uniform,
no-powder and no-deposit paste.
3, Using an inserting tool to insert, making the second time 4~6h
after the first inserting.
4, Scrape the skim coat layer smoothly, control the thickness
5, Can paste other coating 7 days after finishing the skim coat
6, Maintaining the skim coat layer with water 24~48h after
finishing the skim coat layer according to the
humiture, and keep maintaining for 2~3 days.
a, Mixing PB-07 with water into paste, an electric mixer can get
better effect. Put it aside for a few minutes
and then a little stirring to strengthen the hardness.
b, Using an appropriate scraper to scrape the skim coat on the
About 1.8~2.5kg/㎡, based on the smoothness of the surface.
1, Make sure the smoothness and vertical rate of the surface before
2, Never mix the dry slurry with water for second use.
3, The mixed skim coat should be used up within 3h.
4, Polishing within 1~2 days according to the weather.
5, For the base surface polished by cement paste, suggesting PB-08
External Repair Skim Coat.
6, Just polish with the tool marks. Not overly polished to avoid
affecting the putty strength.
according to the smoothness of the surface
1, status: powder, evenly without caking
2,operation: no scratching barrier
3, dry time: under 4h
4, water resistance(48h): normal
5, alkaline resistance(24h): normal
6, shear strength under standard pressure: ＞1.2MPa
7, shear strength after water resistance: ＞0.9MPa
8, shear strength in freeze-thaw: ＞0.9MPa
Store in cool and dry place, unopened product can be saved for one